Provides basic information about each 3ware RAID controller in your system.

To see this page, click Summary in the menu bar.

To see this page, select Information >> Controller Details from the menu bar.

Shows a list of the units on the current controller and provides summary information about each unit.

To see this page, select Information >> Unit Information from the menu bar or click an ID number on the Controller Summary.

To see this page, click an ID number on the Unit Information page.

Shows a list of drives on the current controller and provides summary information about each drive.

To see this page, select Information >> Drive Information from the menu bar.

Shows the SMART data for a specific drive, and shows additional detail information for the drive.

To see this page, click the Port # for a drive on the Drive Information page.

Shows the properties of controller phys for 9750 RAID controllers.

There are two ways to access this page. If you have a direct-attached drive you can access this page from the Information >> Drive Information page by clicking the phy ID for the drive. If all drives are connected via expanders, select Management >> Controller Settings page. Under Other Controller Settings click the # link for Number of Controller Phys.

Lets you view settings that affect the units on the current controller and change some of those settings.

Controller-level settings that can be changed include background task rate, Auto-Rebuild, Auto-Carving, and Carve Size. Some additional policies are shown that can only be changed only in the BIOS or the CLI.

Unit-level settings include specifying the StorSave Profile and enabling or disabling the Write Cache, Read Cache, Auto-Verify, Overwrite ECC, Queuing, and Rapid RAID Recovery.

To see this page, select Management >> Controller Settings from the menu bar.

Lets you view and change the schedule for tasks that affect all units on the current controller.

To see this page, select Management >> Scheduling from the menu bar.

Lets you configure new units and make changes to existing units.

To view this page, select Management >> Maintenance from the menu bar.

Shows a list of alarms, including the specific alarm message, and the exact date and time it occurred.

To view this page, choose Monitor >> Alarms on the menu bar.

Shows the status of a Battery Backup Unit (BBU), if one is installed, and allows you to test the battery.

To view this page, select Monitor >> Battery Backup on the menu bar.

Lists the installed and supported enclosures attached to your 3ware controller.

To view this page, select Monitor >> Enclosure Support on the menu bar.

Shows details about a particular enclosure, including status information. You also can use this page to blink the LED for a particular drive.

To view this page, click the ID number of the Enclosure on the Enclosure Summary page.

Lets you set preferences, including email notification for alarms, passwords, page refresh frequency, whether remote access is permitted, whether command logging is enabled, and the incoming port which 3DM2 will use for listening.

To view this page, click 3DM2 Settings on the menu bar.