;Request ExitCode from last Program
set $ExitCode$ = getLastExitCode
 
;Modify Loglevel
setLogLevel = 4
 
;Check ExitCode
 
if ($ExitCode$ = "0")
	setLogLevel = 5
	comment "ExitCode = "+$ExitCode$+" Setup was successfully run to completion."
	setLogLevel = 4
endif
 
if ($ExitCode$ = "1")
	setLogLevel = 5
	logError "ExitCode = "+$ExitCode$+" Setup failed to initialize."
	isFatalError
endif
 
if ($ExitCode$ = "2")
	setLogLevel = 5
	logError "ExitCode = "+$ExitCode$+" The user clicked Cancel in the wizard before the actual installation started, or chose "No" on the opening "This will install..." message box."
	isFatalError
endif
 
if ($ExitCode$ = "3")
	setLogLevel = 5
	logError "ExitCode = "+$ExitCode$+" A fatal error occurred while preparing to move to the next installation phase (for example, from displaying the pre-installation wizard pages to the actual installation process). This should never happen except under the most unusual of circumstances, such as running out of memory or Windows resources."
	isFatalError
endif
 
if ($ExitCode$ = "4")
	setLogLevel = 5
	logError "ExitCode = "+$ExitCode$+" A fatal error occurred during the actual installation process."
	isFatalError
endif
 
if ($ExitCode$ = "5")
	setLogLevel = 5
	logError "ExitCode = "+$ExitCode$+" The user clicked Cancel during the actual installation process, or chose Abort at an Abort-Retry-Ignore box."
	isFatalError
endif
 
if ($ExitCode$ = "6")
	setLogLevel = 5
	logError "ExitCode = "+$ExitCode$+" The Setup process was forcefully terminated by the debugger (Run | Terminate was used in the IDE)."
	isFatalError
endif
 
;Modify Loglevel
	setLogLevel = 6